
CS45 / CS50 / CS56 Chainsaw
4
Original Instructions Version April 12
• Lack of sleep, tiredness, or physical exhaustion results in lower attention spans, and this in turn can lead to
accidents and injury. When planning your work schedule, allow plenty of time to perform the work and allow
plenty of time for rest. Limit the amount of time you continuously use the chain saw to 30~40 minutes per
session, and take 10~20 minutes of rest between work sessions. Also try to keep the total amount of work
performed in a single day to 2 hours.
Do not operate the chain saw in a tree unless specially trained to do so
Work gear and clothing
• When using your chain saw, always wear strong, durable, work clothing; shirts should be long-sleeved and
trousers should be full-length.
Always
• Wear a helmet and face protector.
• Wear ear protectors.
• Wear gloves with saw protection.
• Wear trousers with saw protection.
• Wear boots with saw protection, steel toe caps with non slip sole.
Warnings regarding handling of fuel
• The engine of the chain saw is designed to run on a fuel oil mixture. This fuel is highly ammable, and you
should never store cans of fuel or rell the tank of the chain saw in any place where there is a source of heat
or re which might ignite the fuel.
• Do not smoke whilst operating the chain saw or relling, keep lit cigarettes away from the chain saw at all
times.
• When relling the tank always turn o the engine rst and carefully make sure that there are no sparks or
open ames anywhere nearby before refuelling.
• If any fuel spillage occurs during refuelling, use a dry rag to wipe any fuel which has been spilled onto the
chain saw before starting the engine.
• After refuelling, screw the fuel cap back tightly onto the fuel tank and then carry the chain saw to a spot 3
metres or more away from where it was refuelled before starting the engine.
Comentarios a estos manuales