Mitox CS50 Manual del operador descargar pdf (Pagina 16)

CS45 / CS50 / CS56 Chainsaw

Original Instructions Version April 12

Operating the Engine

1. Fill fuel (2) and chain oil (1) tanks respectively, and tighten the

caps securely.

2. Set the switch (3) to “I” position.

3. Press the primer button (4) 6 times.

4. Pull out the choke knob (5). The choke will close and the throttle

will be set in the starting position.

5. Push in the decompressor valve (6).

6. Apply the chain brake by pushing the front hand guard (7) forwards.

7. Place the saw on the ground, grip the front handle with your left hand,

place your right foot through the rear handle. Pull the starter handle

with your right hand.

Caution: do not pull the starter cord all the way out and do not let

go of the starter handle if the cord is extended, this can damage

the starter mechanism.

8. When the engine has tried to re, push in the choke knob (5) and then pull the starter handle

again to start the engine.

9. As soon as the engine is running, pull the throttle lever slightly to reset the throttle control to idle.

This must be done as soon as the engine has started to avoid unneccessary wear on the clutch.

NOTE: Disengage the chain brake by pulling the front hand guard towards the front

handle prior to cutting.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Sin comentarios

Mitox CS50 Manual del operador Pagina 16