Mitox CS50 Manual del operador descargar pdf (Pagina 21)

CS45 / CS50 / CS56 Chainsaw

Original Instructions Version April 12

Periodical Service Points

Cylinder Fins

Dust clogging between the cylinder ns will cause

overheating of the engine.

Periodically check and clean the cylinder ns after removing

the cylinder cover.

When installing the cylinder cover, make sure that switch

wires and grommets are tted correctly.

Fuel lter

Using a wire hook, take out the lter (1) from the ller port.

Disassemble the lter and clean with petrol, or replace with

a new one if needed.

Spark plug

Clean the electrodes with a wire brush and reset the gap to

0.65 mm as necessary.

Plug type: NGK: BPRM7A

Sprocket

Check for cracks and for excessive wear interfering with the

chain drive. If the wear is considerable, replace it with a new

a one. Never t a new chain on a worn sprocket, or a worn

chain on a new sprocket.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Sin comentarios

Mitox CS50 Manual del operador Pagina 21