Mitox LS700BS Manual del operador descargar pdf (Pagina 11)

LS700BS 7 Ton Petrol Logsplitter

Original Instructions Version April 13

Read dipstick to determine the maximum and minimum oil level.

To check the hydraulic oil, unscrew the oil ller plug and wipe the dip

stick rod with a clean cloth. Next insert the dip stick into oil tank without

screwing it into the tank. The oil should be between the markings Min

and Max. Top up the oil if necessary.

Low oil can damage the oil pump. Overlling can result in

excessive temperature in the hydraulic transmission system.

SHARPENING WEDGE

This log splitter is equipped with a reinforced splitting wedge with a specially treated blade. After long periods of operation, and

when required; sharpen the wedge using a ne-toothed le removing any burrs or at spots on the edge.

TROUBLESHOOTING

PROBLEM PROBABLE CAUSE REMEDY SUGGESTED

Engine does not start Engine oil level is low Fill engine with oil to correct level

Ignition switch is OFF Set ignition to ON

Log Splitter does not work while motor

running

Bleed valve is not opened Open bleed valve

Control Levers or Connection parts bent Replace the damaged parts

Low hydraulic oil level Check and rell hydraulic oil

Log Splitter works with

abnormal vibration and noise

Low hydraulic oil level Check and rell hydraulic oil

If the solutions above fail to resolve the problem or the machine is not safe to use then contact the suppying dealer.

HYDRAULIC

PLUMBING DIAGRAM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Mitox LS700BS Manual del operador Pagina 11