LS700BS 7 Ton Petrol Logsplitter
10
Original Instructions Version April 13
9. Place log onto splitter. Place the log onto the support table vertically and
sitting at on the support table. Be sure the wedge and support table will
contact the log squarely on the ends. Never attempt to split a log at an angle.
Split log in the direction of its growing grain. Do not
place logs across the log splitter for splitting. It may
be dangerous and may seriously damage the machine.
10. Adjust the Log Holders (A) according to the diameter of the log to obtain
most comfortable Control Levers angle.
11. Hold the log with the clamping brackets. Lower levers to start the
splitting. Releasing either lever stops the motion of the splitting wedge.
Releasing both handles returns the splitting wedge to the upper position.
12. Stack as you work. This will provide a safer work area, by keeping it
uncluttered, and avoid the danger of tripping.
4 WAY SPLITTING CROSS
Mount the 4 way splitting cross over the splitting wedge and secure in
place using the xing screw, ensuring that it is rmly secured.
The 4-way splitting cross is only to be used on freshly
cut wood and not seasoned wood as this type of wood
can splinter and put undue strain on the log splitter.
Accumulated split wood and wood chips can create a
hazardous work environment. Never continue to work in a
cluttered work area which may cause you to slip, trip or fall.
REPLACING HYDRAULIC OIL
The hydraulic system is a closed system with oil tank, oil pump and control
valve. Check oil level regularly with dipstick. Low oil level can damage the
oil pump. Oil Level should measure approx. 1 ~ 2 cm lower than the upper
surface of the oil tank. The oil should be completely changed once a year.
-Make sure moving parts stop and the log splitter is unplugged.
-Make sure that no dirt or debris nds its way into the oil tank
-Collect used oil and responsibly recycle.
-Following an oil change, activate the log splitter a few times without splitting
Hydraulic oil recommended for the log splitter’s hydraulic system:
HLP 22
Use a drain pan to aid in the removal of all used oil and particles.
Remove oil drain plug to drain oil from the hydraulic transmission
system. Examine oil for metal chips as a precaution to future problems.
After oil has been completely drained from the Oil ller, reinstall drain plug.
Fill the hydraulic transmission system with recommended oil through
the ller plug opening, to the correct level.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales